User guide

7
EN
How to Install the Full-Featured RemoteBattery
Theremotebattery(included)isnotinstalledatthe
factory. To install the battery, follow the steps below:
1 Pull out the battery holder.
The battery holder is located on the lower end of
the back of the remote. Use a fingernail inserted
into one of the notches on either the side of
the remote to pull the battery holder out of the
remote.
2 Position the battery (included) so it sits in
the battery holder correctly.
Makesurethepolarity(the+and–sidesofthe
battery)iscorrect.
3 Push the battery holder back into the remote, making sure the
battery stays in place.
You will hear and feel the battery holder click into place.
NOTE Please discard used batteries properly.
How to Dock Your iPhone or iPod
1 Eject the dock connector, if
it’snot already extended.
Depress and release the dock
connector. It’s on the front of
the speaker system and has the
Altec Lansing logo on it. The dock
connectorwillextendintoposition.
2 Place your iPhone or iPod into position.
Align your iPhone or iPod’s connection port with the dock connector
ontheinMotioniMT630speakersystem.SlideyouriPhoneoriPod
onto the dock connector.
NOTE Your iPhone or iPod can be in a skin or thin cover, but not too thick
of a cover in order to dock properly.
How to Turn On Your Speaker System
1 Make sure you have power to the unit.
EnsuretheACadapterisconnectedtothesystemandpluggedinto
thewall.SeetheGetting Started section for more information. If the
batteryischarged,theACadaptercanbedisconnected.
2 Turn on the unit.
Press the
button on either the speaker system or the remote.
How to Turn Off Your Speaker System
Turn off the unit.
Press the
button on either the speaker system or the remote.
Alternately, you can close the support stand to turn off your speaker
system.
NOTE Wheneveryouarenishedlisteningtoyourmusic,pleaseremember
to turn off your speaker system and portable device to conserve energy.