User guide

13
EN
Symptom Possible Problem Solution
iPhone or iPod
didn’tcharge
iPhone or iPod is not installed
properly.
RemoveyouriPhoneoriPodfromthedockandcheckforobstructionsontheconnectors
in the dock and on your iPhone or iPod. Then reseat it in the dock.
iPhone or iPod is locked up. Please make sure your iPhone or iPod is working properly before docking into the unit.
Please refer to your iPhone or iPod manual for details.
ACadapterisn’tpluggedintoa
wall outlet, or the connector is not
pluggedintothepowersupplyjack
on the back of the speaker system.
PlugtheACadapterintoawalloutletandplugtheconnectorintothesupplyjackonthe
speaker system.
Soundisdistorted
Sourcevolumelevelissettoohigh. Decrease the source volume.
Audio source is distorted. IftheiPhoneoriPodoriginalaudiosource(musicle)isofpoorquality,distortionand
noiseareeasilynoticedwithhigh-powerspeakers.Tryadifferentaudiosourcesuchasa
musicCD.
Full-featuredremote
doesn’t work
Battery is weak. Replacecurrentbatterywithanewbattery.
Full-featuredremoteisnotpointed
toward the speaker system.
Pointthefull-featuredremotetowardtheAltecLansingspeakersystemandmovewithin
10feetoftheunit.
No sound from the
AUX device, such as
anMP3playerorCD
player connected to
theAUXjack
Volume on the device is set
toolow.
Increasethevolumeonthedevicetoapproximately¾fullvolume.
SourceselectorisnotsettoAUX. SetsourceselectortoAUX.
Troubleshooting