User guide

5
EN
Getting Started
2 Allow the battery to charge.
Chargingtime:Approximately4hoursforafullcharge.Whenthe
battery is fully recharged, the battery icon is shown as full.
WARNING During the recharging process, it is typical for the battery
to become warm. To be safe, keep flammable materials away from the
speaker system.
How to Disconnect the Rechargeable Battery
1 Unplug the inMotion Classic from the wall outlet.
2 Remove the rechargeable battery compartment cover at the
back of the system by removing the screw.
3 Unplug the battery and remove it.
WARNING There is a danger of explosion if the battery is incorrectly
replaced.Replaceitonlywiththesameorequivalenttype.Donotexposeit
to excessive heat such as sunshine, fire, etc.
BATTERY DISPOSAL The battery used in this product must be properly
recycled or disposed of. Please contact your local recycling center for
proper battery handling and disposal instructions.
RatedVoltage:3.7V Capacity:1800mAh Type:McR18650
How to Install the Full-featured Remote Battery
Thefull-featuredremotebattery(included)isnotinstalledatthefactory.To
install the battery, follow the steps below:
1 Pull out the battery holder.
The battery door is located on the
lowerendoftheremote.Simplypull
the tab to open the battery holder.
2 Position the included lithium coin
battery (CR2025) battery so it sits in
the battery holder correctly.
Makesurethepolarity(the+and–sidesofthebattery)iscorrect.
3 Replace the battery door.
NOTE Please discard used batteries properly.