User guide

15
EN
Ifyouhaveanon-iPodMP3playerorothernon-dockingportableaudio
device,youcanenjoyitthroughyourAltecLansinginMotionClassic
speakersystemaswell.JustconnectitviatheAUXjack.Here’show:
1 Locate a 3.5 mm stereo cable
(not included).
2 Plug one end of the stereo cable
into your device.
Your device should have either a
headphoneorLINEOUTjackforyou
to plug into.
3 Plug the other end of the stereo
cable into your speaker system’s
AUX jack.
TheAUXjackislocatedontheback
of the unit.
4 Select “AUX” mode.
Pressthe“SOURCE”buttononyour
speaker system or the full-featured
remote until “AUX” appears on the
speaker system’s LCD.
5 Turn on your device and start it playing.
6 Adjust the volume.
Usethe“+”and“–”buttonsonthespeakersystemorfull-featured
remotetoadjustthevolume.
NOTE Youmayneedtoadjustthedevicevolumealso.Yourdevice’s
volume should be set to approximately ¾ volume.
7 When you are finished listening to your portable audio device,
please remember to turn both it and your speaker system off
to conserve electricity.
Maintaining Your Speaker System
Place your speaker system on a level surface away from sources of direct
sunlight or excessive heat.
Protect your furniture with a cloth or other protective material when placing
your speaker system on a natural wood or lacquered finish.
Clean your speaker system with a soft cloth moistened only with mild soap
andwater.Strongercleaningagents,suchasbenzene,thinnerorsimilar
materials, can damage the surface of the unit.
Listening to a Non-docking iPod or Other Portable Audio Device