Installation & Assembly

NOTE: Step 6 is recommended to ensure that that the bottom of the sink

has enough support. This step is optional.

Step 6: Cut and fit a

" thick plywood board that will sit on top of the beams.

Step 7: Cut-out the sections where your drain and faucet lines will be.

These will depend on the type of installation you chose

(Under-the-counter, flush-mount, semi-recessed).

Step 8: fit the board on top of the beams and verify that it is leveled.

If not leveled, adjusted with shims.

Step 9: Secure the board to the beams with wood. Verify the the board is still

leveled.

NOTE: Due to the variety of installations possible with this sink, your installer

may suggest a different support frame design.

Step 10: Place the sink over the plywood. Check that the drain and faucet-line

cut-outs line-up correctly. Confirm that the sink is leveled and adjust if

not.

Step 11: Place the countertop over the cabinet and kitchen sink. Verify that

The sink is installed properly.

NOTE: This completes the sink installation. Follow the directions of the

countertop to complete your installation

Step 12: Connect water supply and drainage system per manufacturer’s

instructions. Run water to test for leakage. .

ALTAIR