User`s manual
Table Of Contents
- Introduction
- User Interface
- Display Elements
- Cross Country Tasks
- Glide Computer
- Atmosphere and Instruments
- Airspace, Traffic and Team Flying
- Avionics and Airframe
- Quickstart
- InfoBox Reference
- Configuration
- Data Files
- About XCSoar
- GNU General Public License
11 CONFIGURATION
• Target up when circling This is equivalent to track-up in cruise and the bearing to next
waypoint up when circling.
• North/track North-up in cruise, glider track-track up in circling
• Auto zoom Determines whether auto-zoom is enabled. Auto-zoom changes the zoom level dur-
ing flight so that the map zooms in as the active waypoint is approached. After passing a
waypoint, the map zooms out to the next waypoint.
• Circling zoom This determines whether separate zoom levels will be maintained for circling and
cruise modes. If unchecked, there is only one zoom. If enabled, then the map will zoom in
automatically when entering circling mode and zoom out automatically when leaving circling
mode.
• Trail drift Determines whether the trail is drifted with the wind when displayed in circling mode.
When OFF, the trail is uncompensated for wind draft.
• Trail width Sets the width of the trail display.
• Wind arrow Determines the way the wind arrow is drawn on the map.
• Arrow head Draws an arrow head only
• Full arrow Draws an arrow head with a dashed arrow line
XCSoar Manual (Altair version) • XCSoar-A-EN 98