Use and Care Manual

Table Of Contents

—

NOTE: Specialized tools may be necessary to install a Vessel Sink with countertop materials

other than wood, marble, or granite.

SUGGESTED TOOLS ANDMATERIALS

Pencil

PARTS LIST

Safety

Glasses

Drill

Tape

Measure

Silicone

Adhesive

Acetone

Sink Sink Faucet (not included) Sink Drain (not included)

1. Read the complete instruction manual before beginning installation.

Confirm that your model will fit in intended location and plumbing fixtures are

located where legally required before beginning installation.

Two people are recommended to install and move this product.

Mark Faucet Holes and Drain Location

· Place sink in desired location on countertop and mark the drain hole and faucet hole with a pencil.

NOTE: Make sure clearance is suitable for backsplash, faucet, and plumbing for the sin

PAGE 1
SUGGESTED TOOLS AND MATERIALS Safety Glasses Pencil Tape Measure Drill Silicone Adhesive Acetone PARTS LIST Sink Sink Faucet (not included) Sink Drain (not included) NOTE: Specialized tools may be necessary to install a Vessel Sink with countertop materials other than wood, marble, or granite. 1. 2. 3. Read the complete instruction manual before beginning installation.
PAGE 2
. Drill Countertop · Cut the opening for the drain in the countertop. ALWAYS WEAR PROTECTIVE GEAR WHEN USING DANGEROUS MATERIALS 3. Install Faucet · Install faucet and its components. 4. Install Sink · Check alignment of the sink to the opening in the countertop. · Use a bead of clear silicone (or preferred adhesive) around the underside of the sink. · Carefully place the sink on the countertop, align, and press firmly. · Allow sealant to set above 60 minutes.