Instructions / Assembly

Important:
We recommend that this product is installed by a qualified professional contractor.
Do NOT overtighten the waste as this may cause long term damage to the bath.
Never use abrasive detergents or disinfectants or those containing alcohol, hydrochloric acid or phosphoric acid.
1. Remove cap, screw and gasket from fitting;
3. Tighten the screw to the overflow body;
4. Aim another side to the drain hole and screw the pop up cover slowly, but donot
overtighten it;
5. Loosen the screws on the three pipes and strentch the pipes to the appropriate length,
fitting for the bathtub, and then tighten the screws.
6. Connect approproate drain pipe;
7. Check if there's any leakage.
52167-BAT-GR-BB
Altair Inc.