User's Manual

Altai A8n (ac) Series Super WiFi Base Station

Configuration Guide

Radio Settings

Radio Status – indicate the current status of Radio 0 interface

MAC – MAC address of Radio 0 interface

Radio Channel - indicate operating frequency (channel) of Radio 0

Wireless Mode – indicate 802.11 standards that Radio 0 operates

Mode – indicate operating mode of Radio 0

Country Code – indicate country code setting of Radio 0

Transmission Power – indicate the total transmission power of Radio 0

Channel Usage List

Tx(%) – average transmit frames percentage of operating channel

Rx(%) – average receive frames percentage of operating channel

Busy (%) – average busy state percentage of operating channel

Noise Floor (dBm) – in ate noise floor of operating channel and noise

floor of chain 0, chain 1, and chain 2 on the control channel; if

operating with 40MHz bandwidth, it shows the noise floor of chain 0,

chain 1, and chain 2 on the extension channel as well.

Interference Mitigation Offset (0-50dB) – signal offset option that will

mask all noise / valid signal below 0-50 dB; 0 denotes disabled

Nearby AP List

If Nearby AP List is enabled, device collects nearby AP information and

builds Nearby AP List from all beacon frames received during operation.

Information shows the SSID, BSSID, authentication mode, cipher mode,

operating channel, data rate, and received SNR of collected APs.

Tx/Rx Statistics

This statistic shows traffic distribution about Radio 0 interface. The

statistical data includes distribution in terms of data rate and frame

type for all incoming and outgoing data frame via Radio 0 interface.