User's Manual

48
Altai A8n (ac) Series Super WiFi Base Station
Configuration Guide
Altai Technologies Ltd. All rights reserved
4.2.7. Enable Spanning Tree Protocol (STP)
Figure 47 – STP Setting
1. Go to Configuration > Network > General > STP Setting
2. Select Enable STP to enable spanning tree protocol on A8n (ac)
device
3. Click Submit
4. Click Save & Apply
4.2.8. Configure the operating mode on Ethernet
interface
Figure 48 – Ethernet Setting
1. Go to Configuration > Network > General > Ethernet Setting
2. Change the following settings:
Mode – Select the operating mode on Ethernet 0:
Auto
A8n (ac) device negotiates with connected device
automatically and selects the best option
Manual
Network administrator select speed and duplex mode
manually
Speed (Eth0) – Select the speed and duplex mode on Ethernet 0. It is
only available if Manual is selected in Mode:
10Mbps/Half
10Mbps/Full
100Mbps/Half
100Mbps/Full
MTU – Select the Maximum transmission unit on Ethernet 0. Default is
1500 Bytes.
3. Click Submit
4. Click Save & Apply