User's Manual

45
Altai A8n (ac) Series Super WiFi Base Station
Configuration Guide
Altai Technologies Ltd. All rights reserved
Enable Syslog – Select the checkbox to enable system logging
function
Server IP Address – Type in IP address of the remote syslog server
that AP sends system logs instantaneously. 0.0.0.0 denote that AP
saves the syslog in its local memory
Severity – Set severity level of log that AP stores / sends to remote
syslog server:
Emergency
A "panic" condition usually affecting multiple
apps/servers/sites. At this level it would usually notify all
tech staff on call.
Alert
Should be corrected immediately, therefore notify staff
who can fix the problem. An example would be the loss
of a primary ISP connection.
Critical
Should be corrected immediately, but indicates failure in
a secondary system, an example is a loss of a backup
ISP connection.
Error
Non-urgent failures, these should be relayed to
developers or admins; each item must be resolved within
a given time.
Warning
Warning messages, not an error, but indicate that an
error will occur if action is not taken, e.g. file system 85%
full - each item must be resolved within a given time.
Notice
Events that are unusual but not error conditions - might
be summarized in an email to developers or admins to
spot potential problems - no immediate action required.
Informational
Normal operational messages - may be harvested for
reporting, measuring throughput, etc. - no action
required. (Default Setting)
Debug
Info useful to developers for debugging the application,
not useful during operations.
3. Click Submit
4. Click Save & Apply
4.2.3. Configure historical statistics settings
Figure 44 – Historical Statistic Setting
1. Click Configuration > System
2. Change the following settings:
Enable Historical Statistics - Select the checkbox to enable AP
statistics function