User's Manual

Altai A8n (ac) Series Super WiFi Base Station

Configuration Guide

If Authentication Mode is WPA-auto:

TKIP + AES - This algorithm automatically selects TKIP or AES based on the

client’s capabilities

Note:

- TKIP is not supported by 802.11n standard. If selected TKIP, the

802.11n’s devices will be limited to 802.11g transfer rate, i.e.

up to 54 Mbps

4. Provide suitable identification in NAS identifier. Remote RADIUS

server use this ID to identify its clients [WPA or WPA2 only]

5. Provide transmission timeout interval between 0 and 86400s in

RADIUS Retry Timeout [Optional]. 300 is default setting.

6. Provide IP address of remote RADIUS server for authentication in IP

Address of RADIUS Server

7. Provide service port of remote RADIUS server in Port of RADIUS Server.

1812 is default setting.

8. Provide suitable secrets in Secret of RADIUS Server. It is used along

with the MD5 hashing algorithm to obfuscate passwords. This secret

MUST be as the same as that in RADIUS server.

9. Repeat step 7-9 if the backup RADIUS server is available.

10. RADIUS Accounting Server Setting is optional; you may select if the

WLAN requires accounting service from remote RADIUS server. You

can change the following settings:

Accounting interim Interval - indicates the number of seconds

between each interim update in seconds; 300 is default setting.

IP Address - IP address of remote RADIUS Accounting Server

Port - Service port of remote RADIUS server for accounting service.

1813 is default setting.

Secret - Password MUST be as the same as that in RADIUS server

11. Click Submit

12. Click Save & Apply