User's Manual

Altai A8n (ac) Series Super WiFi Base Station

Configuration Guide

3. Summary of Basic Configuration Tasks

This chapter summarizes the quick setup procedures for configuring

A8n (ac) Series products to operate in different roles in your network,

including Access Point (AP), Station (CPE/STA), and Repeater.

3.1. Configure as Access Point (AP)

1. Go to Configuration > Network > General > WAN Settings

2. Select suitable internet connection type (DHCP / Static)

Figure 7 – WAN Setting (IPv4)

3. Configure IP Address on the device (static internet connection only)

4. Click Submit

5. For 2.4G Radio: Go to Configuration > Wireless > Radio0(2.4G) >

General

For 5G Radio: Go to Configuration > Wireless > Radio1(5G) >

General

Figure 8 – 2.4G Radio General Setting of AP

6. Select AP in Operating Mode

7. Select suitable Country Code that matches your device’s installation

location.

8. Select suitable Wireless Mode

802.11 ng HT20 is recommended option on 2.4G radio;

802.11 ac HT80 is recommended option on 5G radio

9. Select the suitable Radio Frequency.

10. Select the suitable Transmission Power.

11. Click Submit