User's Manual

TPS12-016_rev1 1_A8Ein_web-admin_Configuration_Manual_-_fm_1 2 0 604 (for FCC & IC) 20130322.doc

Commercially Confidential

Figure 90 Information after firmware update

7.7 RESTORE FACTORY DEFAULT

There are 2 ways to reset the system back to factory default settings.

 via user interfaces (eg. SSH/Console/Web)

 via hardware reset button

7.7.1 RESET BACK TO FACTORY DEFAULT VIA USER INTERFACES

Under Aministration -> Factory Default, user can reset the A8Ein back to Factory Default

Configuration.

Figure 91 Restore to Factory Default

Procedures:

Reset to Factory Default：Press this button to reset A8Ein to Factory Default Configuration.

Retain Network Address): Select this if user doesn’t wish to reset the IP address

configuration to factory default.