User's Manual

TPS12-016_rev1 1_A8Ein_web-admin_Configuration_Manual_-_fm_1 2 0 604 (for FCC & IC) 20130322.doc

Commercially Confidential

6.2 BASIC CONFIGURATION

6.2.1 NTP CONFIGURATION

NTP is a network time protocol for the A8Ein BTS to synchronize the system time. NTP is disabled

by default. If NTP is needed, IP address of the NTP server must be added and A8Ein will

synchronize with the NTP server. It is useful to maintain the network and make sure all APs are

using the same system time by setting the same NTP server.

Please select Configuration -> System to configure NTP setting.

Figure 33 NTP Setting

Enable NTP： Enable or disable NTP function, by default it is selected.

NTP Server IP： NTP server IP address, please click “ ” to add new NTP server IP

address.

NTP Polling Interval： By default, it is 600s

NTP Time Zone： Time Zone setting, by default it is Asia/Hong Kong.

Daylight Saving Time： By default, it is not selected.

Procedures：

1 Select Configuration->System， to go to system setting page.

2 Select Enabled NTP to enable NTP.

3 Add NTP IP address in NTP Server IP.

4 Set NTP Polling Interval

5 Choose local NTP Time Zone

6 Set Daylight Saving Time（optinal）

7 Click Submit

8 Click Save&Apply to commit changes.

6.3 NETWORK CONFIGURATION

Please select Configuration -> Network to go to Network configuration page.