User's Manual

Altai A3 Series Dual-band 3x3 802.11 ac WiFi Access Point

Configuration Guide

7.1.2. How to perform channel scan on 5G radio

1. Go to Tools > Channel Scan > Radio 1 (5G)

2. [Optional] Provide channel scan interval from 100ms to 1000ms in

Duration

3. Click Start Scan

4. Wait until Scan Status is changed from In Process to Success; it will

take for 20 seconds approximately

Note:

- Wi-Fi service will be interrupted during channel scan

7.2. Diagnosis

7.2.1. Ping Test

Network administrator and engineer test the reachability of a host and

measures the round-trip time between A3 and the host over an Internet

Protocol (IP) network by using ping tool.

Figure 102 – Ping Test

7.2.2. How to perform ping test

1. Go to Tools > Diagnosis > Ping

2. Type target IP address / host name in Ping IP Address/Host Name

3. [Optional] Specify how many ICMP (ping) packet that A3 sends to

the target host in Packet Count; 4 is default setting

4. [Optional] Specify the packet size of ICMP packet in Packet Size; 56

is default setting

5. Click Start

6. Click Stop to terminate ping test if necessary