User's Manual

Altai A3 Series Dual-band 3x3 802.11 ac WiFi Access Point

Configuration Guide

6.4. Status > Radio1(5G)

6.4.1. Status > Radio1(5G) > Status

Figure 96 – Radio 1 Status Information

6.4.1.1. Radio Settings

Radio Status – indicate the current status of Radio 1 interface

MAC – MAC address of Radio 1 interface

Radio Channel - indicate operating frequency (channel) of Radio 1

Wireless Mode – indicate 802.11 standards that Radio 1 operates

Mode – indicate operating mode of Radio 1

Country Code – indicate country code setting of Radio 1

Transmission Power – indicate the total transmission power of Radio 1

6.4.1.2. Channel Usage List

Tx(%) – average transmit frames percentage of operating channel

Rx(%) – average receive frames percentage of operating channel

Busy (%) – average busy state percentage of operating channel

Noise Floor (dBm) – indicate noise floor of operating channel and noise

floor of chain 0, chain 1, and chain 2 on the control channel; if

operating with 40MHz bandwidth, it shows the noise floor of chain 0,

chain 1, and chain 2 on the extension channel as well.

Interference Mitigation Offset (0-50dB) – signal offset option that will

mask all noise / valid signal below 0-50 dB; 0 denotes disabled

6.4.1.3. Nearby AP List

If Nearby AP List is enabled, device collects nearby AP information and

builds Nearby AP List from all beacon frames received during operation.