User's Manual

Altai A3 Series Dual-band 3x3 802.11 ac WiFi Access Point

Configuration Guide

Rx(%) – average receive frames percentage of operating channel

Busy (%) – average busy state percentage of operating channel

Noise Floor (dBm) – indicate noise floor of operating channel and noise

floor of chain 0, chain 1, and chain 2 on the control channel; if

operating with 40MHz bandwidth, it shows the noise floor of chain 0,

chain 1, and chain 2 on the extension channel as well.

Interference Mitigation Offset (0-50dB) – signal offset option that will

mask all noise / valid signal below 0-50 dB; 0 denotes disabled

6.3.1.3. Nearby AP List

If Nearby AP List is enabled, device collects nearby AP information and

builds Nearby AP List from all beacon frames received during operation.

Information shows the SSID, BSSID, authentication mode, cipher mode,

operating channel, data rate, and received SNR of collected APs.

6.3.1.4. Tx/Rx Statistics

This statistic shows traffic distribution about Radio 0 interface. The

statistic data includes distribution in terms of data rate and frame type

for all incoming and outgoing data frame via Radio 0 interface.

6.3.2. Status > Radio0(2.4G) > Association List

This information is available on AP mode and Repeater mode only.

Figure 94 – Radio 0 Association List

6.3.2.1. WAN

It shows the current status of all operating WLAN on Radio 0 interface.

The information includes WLAN ID, SSID, MAC Address, authentication

mode, cipher mode, number of associated clients, instant throughput,

and total traffic of each operating WLAN respectively.

6.3.2.2. Station List

It shows the real time status of first 50 associated stations. The status

includes Station ID, MAC Address, IP address, SNR(dB) of uplink, RSSI