User's Manual

50
Altai A3 Series Dual-band 3x3 802.11 ac WiFi Access Point
Configuration Guide
Altai Technologies Ltd. All rights reserved
4.2.6. Enable Spanning Tree Protocol (STP)
Figure 52 – STP Setting
1. Go to Configuration > Network > General > STP Setting
2. Select Enable STP to enable spanning tree protocol on A3 device
3. Click Submit
4. Click Save & Apply
4.2.7. Configure the operating mode on Ethernet
interface
Figure 53 – Ethernet Setting
1. Go to Configuration > Network > General > Ethernet Setting
2. Change the following settings:
Mode (Eth0 and Eth1) – Select the operating mode on Ethernet 0
and Ethernet 1 respectively:
Auto
A3 device negotiates with connected device
automatically and selects the best option
Manual
Network administrator select speed and duplex mode
manually
Speed (Eth0 and Eth1) – Select the speed and duplex mode on
Ethernet 0 and Ethernet 1 respectively. It is only available if Manual is
selected in Mode:
10Mbps/Half
10Mbps/Full
100Mbps/Half
100Mbps/Full
1000Mbps/Full
3. Click Submit
4. Click Save & Apply