User's Manual

Altai A3 Series Dual-band 3x3 802.11 ac WiFi Access Point

Configuration Guide

4.1.5. Configure Radio Interface as Repeater

4.1.5.1. Radio 0 – 2.4GHz Radio

4.1.5.1.1. Radio General Configuration

Figure 43 – Radio 0 General Setting of Repeater

1. Go to Configuration > Wireless > Radio0(2.4G) > General;

2. Select Enable Radio checkbox to enable radio interface

3. Select Repeater in Radio Mode

4. Change the following settings:

Country Code – Select an option that matches your device’s

installation location; Hong Kong is the default setting.

Note:

- Country code sets the regulatory domain for maximum

transmission power that Repeater can use

Transmission Power – Select the total transmission power for the

radio interface.

Maximum Client – Specify the maximum associated client between

1 and 256 that the radio interface serves. 256 is the default setting.

Enable Inter-WLAN User Isolation - Select the checkbox to block the

users’ communication across different SSID in the AP directly.

5. Click Submit

6. Click Save & Apply