User's Manual

Altai A3 Series Dual-band 3x3 802.11 ac WiFi Access Point

Configuration Guide

Dynamic Radio Frequency Selection (DFS) – Select to enable

automatic channel selection that selects the least congested

channel where radar is not detected during booting up.

Note:

- Radio Frequency is set as auto if DFS is enabled

Radio Frequency – Choose the operating channel for the radio

interface; AP selects the channel with the least amount of

interference if Auto is selected. 5180MHz (Channel 36) is the default

setting

Transmission Power – Select the total transmission power for the

radio interface.

Maximum Client [Optional] – Specify the maximum associated

client between 1 and 256 that the radio interface serves. 256 is the

default setting.

Disable HT20/HT40 Auto Switch [Optional] – If select the checkbox,

AP will NOT switch the channel width between 20 MHz and 40 MHz

automatically. This option is only available if any wireless mode with

HT40+/- is selected.

Enable Inter-WLAN User Isolation [Optional] - Select the checkbox to

block the users’ communication across different SSID in the AP

directly.

Periodic Auto channel Section [Optional] – Select the checkbox to

enable scheduled channel selection task on the radio interface:

Schedule Mode

Select exact time and day(s) for selecting radio

frequency for the interface

Periodic Mode

Select a countdown timer (minute) for selecting radio

frequency for the interface; 0 denotes disable.

5. Click Submit

6. Click Save & Apply