User's Manual

Altai A3 Series Dual-band 3x3 802.11 ac WiFi Access Point

Configuration Guide

2.4G 216.7Mbps (802.11 n-only HT20)

2.4G 450Mbps (802.11 ng HT40+)

2.4G 450Mbps (802.11 n-only HT40+)

2.4G 450Mbps (802.11 ng HT40-)

2.4G 450Mbps (802.11 n-only HT40-)

Radio Frequency – Choose the operating channel for the radio

interface; AP selects the channel with the least amount of

interference if Auto is selected. 2412MHz (Channel 1) is the default

setting

Note:

- Select the radio frequency based on the result of channel

scan is recommended

Transmission Power – Select the total transmission power for the

radio interface.

Maximum Client – Specify the maximum associated client between

1 and 256 that the radio interface serves. 256 is the default setting.

Disable HT20/HT40 Auto Switch [Optional] – If select the checkbox,

AP will NOT switch the channel width between 20 MHz and 40 MHz

automatically. This option is only available if any wireless mode with

HT40+/- is selected.

Enable Inter-WLAN User Isolation [Optional] - Select the checkbox to

block the users’ communication across different SSID in the AP

directly.

Periodic Auto Channel Section [Optional] – Select the checkbox to

enable scheduled channel selection task on the radio interface.

Schedule Mode

Select exact time and day(s) for selecting radio

frequency for the interface

Periodic Mode

Select a countdown timer (minute) for selecting radio

frequency for the interface; 0 denotes disable.

5. Click Submit

6. Click Save & Apply

Comment [t4]: Suggest to rewrite

the description. There are way too

many “select” and it gets very

confusing. I think channel selection

task here is performed by AP.

Therefore, we should use ACS to

distinguish from manual channel

selection by user