User's Manual

Altai A3 Series Dual-band 3x3 802.11 ac WiFi Access Point

Configuration Guide

2.2. Connect to Your Altai Access Point

1. Connect your laptop to Data/IN port on the PoE Injector provided in

the Altai’s package using Ethernet cable

2. Connect the Ethernet port of AP to P+D/Out port on the PoE Injector

provided in the Altai’s package using Ethernet cable.

Note:

- Connect to Eth0 for A3c and A3w to P+D/Out port on the

PoE Injector

3. Connect the power cord to the power port on the PoE Injector.

Connect the other end of the power cord to a power outlet.

Figure 1 – A3-Ei Connection Diagram

Figure 2 – A3c / A3w Connection Diagram

4. Verify the AP’s Power LED is steady orange (Thick AP) or steady

green (Thin AP) after a minute