User's Manual

TPS09-005_rev1 0_A3_Configuration_Manual_-_fm_1 0 0 6 _FCC.doc

Commercially Confidential

After selecting Open or Shared-Key for Authentication Mode, WEP for Cipher Mode, the WEP

key settings can be defined as shown in Figure 21.

WPA/WPA2 or WPA-PSK/WPA2-PSK can be enabled by selecting WPA/WPA2 or

WPA-PSK/WPA2-PSK for Authentication Mode. The AES and TKIP are the two available

options for Cipher Mode. The related settings are shown in Figure 20 and Figure 23.

NOTE: Click the Update icon to store the WEP or WPA settings.

Figure 21 WEP Key Settings

Figure 22 WPA Settings

RADIUS server is used for authentication. A3 smart WiFi can store separate RADIUS server

address for each VAP. It is only visible when the Authentication Mode is set to “WPA”. The

default setting of RADIUS server port is 1812. RADIUS secret shared password between the

RADIUS server and A3 smart WiFi. A password up to 128 characters long can be added. The

VLAN IP address and VLAN Subnet Mask configured on the VAP security web page will be

used only when A3 runs in the following conditions.