User's Manual

TPS09-005_rev1 0_A3_Configuration_Manual_-_fm_1 0 0 6 _FCC.doc
Commercially Confidential
21
4.9.1.1 WAN Interface
Default setting is "Ethernet". This control is used to specify the WAN interface. The Ethernet
interface or 5G bridge interfaces can be used as the WAN interface when VAP0 works on the
AP mode. Use the pull down menu to select either one. The 2.4G Radio Client interface is
used as the WAN interface when VAP0 works on the Station mode.
4.9.1.2 PPPoE Configuration
If PPPoE is chosen, a PPPoE login will be attempted for the PPPoE Username, PPPoE
Password and PPPoE Service Name, see Figure 13.
Figure 13 PPPoE Configuration
NOTE: The DNS Auto Update should be set to Disable when using PPPoE. User need
to configure the DNS server IP address manually.
PPPoE Active Mode, Max Idle Time and Redial Period can be configured.
When “Connect on Demand” is selected, PPPoE will establish the connection with the remote
access concentrator only when hosts in the local subnet need to access the internet. If the
parameter is set “Keep Alive”, PPPoE will establish the connection with the remote access
concentrator upon boot-up.
Default setting of Max Idle Time is 30 minutes. Only when PPPoE works under Connect on
Demand mode, it will be disconnected if PPPoE connection has been idle for the Max Idle
Time.
When last attempt failed, A3 smart WiFi will attempt to establish the PPPoE connection at
Redial Period.