User's Manual

TPS09-005_rev1 0_A3_Configuration_Manual_-_fm_1 0 0 6 _FCC.doc
Commercially Confidential
20
NOTE: DNS Auto Update can only be enabled when DHCP client is enabled. If the
DNS Auto Update is enabled, it must be used in conjugation with either the DHCP Client or the
PPPoE Mode being enabled. If both the DHCP Client and the PPPoE Mode are disabled then the
DNS Auto Update must also be set to Disabled.
4.9 G ATEWAY M ODE
In Gateway mode, by clicking Network Configuration in the System page, users can configure
the WAN and LAN settings.
Figure 12 Network Configurations under Gateway mode
4.9.1 WAN Configuration
NAT is set to “Enabled” as default.
The settings for Static IP address and DHCP Client are similar to those in switch mode. Please
refer to the previous section for details.