User's Manual

C1n_Configuration_Manual_-_fm_1.0.0.x_for_US_&_Canada_20130116.doc

Commercially Confidential

7 FREQUENCY ASK QUESTION

Q1) Before any configuration, why my computer cannot access to C1n web page?

 Make sure C1n Power LED lights green

 Make sure C1n Ethernet LED lights green

 Make sure your computer LAN Connection IP address is configured as 192.168.1.2. The IP

address of your LAN can be found in LAN connection status.

First, click Start -> Control Panel -> Network Connections. Double click on Local Area

Connection. Under General tab, the Status should be displayed as Connected. If not, please

check the network cable connection or replace the network cable.

Then, click on Support tab. Address type should be Manually Configured and it shows the IP

address.

 Make sure your computer can ping to C1n.

First, click Start -> Accessories -> Command Prompt.

Second, type ping 192.168.1.20

If the connection is successful, the result should be shown as the following:

If the ping result appears request timed out, please verify the network cable connection.

Q2) Why C1n CPE mode cannot associate to my AP?

 Verify the connection status by clicking on 2.4GHz associated AP

 Make sure C1n is configured as station mode

 Verify the SSID, authentication and cipher mode are correctly configured.

 Make sure the AP side MAC address filter has included the C1n 2.4GHz radio MAC

address or the filter is disabled.

 Verify the network cable between C1n and laptop is working properly.