User's Manual

C1n_Configuration_Manual_-_fm_1.0.0.x_for_US_&_Canada_20130116.doc
Commercially Confidential
43
4.14 RESTORE CONFIGURATION TO DEFAULT SETTING
Restoring configuration to factory default can be achieved by hardware reset or software reset.
For software reset, the choices of factory default can be chosen by selecting Factory Default
under Administrations in the menu bar.
The default settings (IP Address, Subnet Mask, Default Gateway Address and Remote
Bridge Configurations are retained) can be restored by selecting the icon Reset to Factory
Default (address retained) or Reset to Factory Default, as shown in Figure 36 Reset to
Factory Default Setting in Web-admin. Please reboot the C1n CPE/AP afterwards.
Note: after resetting to factory default without address retained, please type
<http://192.168.1.20> to open C1n CPE/AP web-admin.
Figure 36 Reset to Factory Default Setting in Web-admin
For hardware reset, a reset button can be found next to the Ethernet port on C1n. First, make
sure the C1n is already powered up. Then, press and hold the C1n reset button until the power
LED turns off. Hardware reset will reset the C1n to factory default without retaining IP
address.