User's Manual

C1n_Configuration_Manual_-_fm_1.0.0.x_for_US_&_Canada_20130116.doc

Commercially Confidential

4.11.11 Lock to AP MAC and Min. AP Signal

The “Lock to AP Mac” function is used to allow the CPE to maintain connection to a particular

AP with a specific MAC under Station mode. With AP lock on, the CPE will lock to the defined

MAC address and no roam between several Access Points with the same SSID. The MAC

address will be automatically filled in when user chooses the preferred SSID from scanning list.

Min AP signal can be configured under station mode VAP. C1n measure the signal strength of

remote SSID. Station mode VAP can only associate to remote SSID with higher signal strength

than min AP signal threshold. Default Min.ap signal Strength value is "-94". The value can be

set from -94 to -10.

The MAC address of the preferred AP can be inputted, if the AP is found and the signal strength

is higher than the min.ap signal strength, the C1n will connect to the AP. If the C1n received

signal is lower than the min.ap signal strength and does not have the Lock MAC address set, it

will connect to another AP with same broadcast SSID.

4.11.12 AP Mode

By clicking AP, user can switch C1n from Station mode to AP mode. When C1n works under

AP mode, C1n is as an access point. Clients can associate to C1n with wired backhaul. Under

AP mode there are 4 VAP, each of the VAPs can be set to different SSID, security and

encryption.

Figure 25 AP mode Setting