User's Manual

C1_Configuration_Manual_-_fm_1.0.0.1.doc
Commercially Confidential
28
4.11.5 2.4G Radio Channel Scanning and Preferred AP Mac
Under Repeater Mode, C1 will automatically scans neighboring AP SSID by clicking Scan icon.
Channel scanning result is list on the web-page, as shown in Figure 21 . Administrator can
choose the appropriate SSID as C1 repeater mode wireless backhaul.
Figure 21 2.4G Radio Channel Scanning
One preferred AP Mac address could be added to Station Mode VAP, shown in Figure . C1
Super WiFi CPE will only associate to the SSID with matching MAC address.
4.11.6 Minimum AP signal
Min AP signal can be configured under station mode VAP. C1 measure the signal strength of
remote SSID. Station mode VAP can only associate to remote SSID with higher signal strength
than min AP signal threshold.
4.11.7 Access Control List (ACL)
By selecting Access Configurations, a window, as shown in Figure , is brought up for choosing
the ACL mode, adding MAC Address with ACL Type (Allow or Deny).
There are three modes in the Access Control List (ACL). They are Disabled, Enabled-Allow and
Strict-Deny:
1. Disabled
- The function of ACL is disabled.
2. Enabled–Allow
- The function of ACL is enabled.
- The MAC addresses which are specified in the ACL will consider as Allow.
- i.e. No computer can access to the base station, unless the computer which has an
MAC address matches one of the entries of the ACL with its ACL Type is Allow.