User's Manual

C1_Configuration_Manual_-_fm_1.0.0.1.doc

Commercially Confidential

NOTE: The DNS Auto Update should be set to Disable when using PPPoE. User need

to configure the DNS server IP address manually.

PPPoE Active Mode, Max Idle Time and Redial Period can be configured.

When “Connect on Demand” is selected, PPPoE will establish the connection with the remote

access concentrator only when hosts in the local subnet need to access the internet. If the

parameter is set “Keep Alive”, PPPoE will establish the connection with the remote access

concentrator upon boot-up.

Default setting of Max Idle Time is 30 minutes. Only when PPPoE works under Connect on

Demand mode, it will be disconnected if PPPoE connection has been idle for the Max Idle

Time.

When last attempt failed, C1 CPE will attempt to establish the PPPoE connection at Redial

Period.

4.9.2 LAN Configuration

In Gateway Mode, the C1 can be a DHCP server, a DHCP relay or none of them.

When the DHCP Server Mode sets to Server, the C1 will act as a DHCP server and use the

settings specified in the field Start IP Address, Maximum Number of DHCP Users and DNS to

serve the wireless clients.

1. Configure the Local IP Address and Subnet Mask Length. Local IP Address is the

gateway IP address for the client who associates C1 CPE. Only the clients under the

same subnet of local IP address can get IP address from C1 Super WiFi CPE.

2. Configure the Start IP Address, Maximum Number of DHCP Users, and DNS, see

Figure 14.

3. Reboot the C1

Figure 14 Configure DHCP Server