User's Manual

C1_Configuration_Manual_-_fm_1.0.0.1.doc

Commercially Confidential

4.9.1 WAN Configuration

NAT is set to “Enabled” as default.

The settings for Static IP address and DHCP Client are similar to those in switch mode. Please

refer to the previous section for details.

4.9.1.1 WAN Interface

Default setting is "Ethernet". This control is used to specify the WAN interface. The Ethernet

interface or 5G bridge interfaces can be used as the WAN interface when VAP0 works on the

AP mode. Use the pull down menu to select either one. The 2.4G Radio Client interface is

used as the WAN interface when VAP0 works on the Station mode.

4.9.1.2 PPPoE Configuration

If PPPoE is chosen, a PPPoE login will be attempted for the PPPoE Username, PPPoE

Password and PPPoE Service Name, see Figure 13.

Figure 13 PPPoE Configuration