User's Manual

iii

Altai C2s

Dual-Band 2x2 802.11ac

WiFi AP/CPE

Installation Guide

Radio Frequency Interference Requirements

This device complies with Part 15 of FCC Rules.

Operation is subject to the following conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including

interference that may cause undesired operation.

3. This device should not be co-located or operating in conjunction with

any other antenna or transmitter.

Interference Statement

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules; these limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: To assure continued compliance, (example – use only shielded

interface cables when connecting to computer or peripheral devices). Any

changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate this equipment.

Warning

The antenna(s) used for this transmitter must be installed to provide a

separation distance of at least 45 cm from all persons and must not be

collocated or operating in conjunction with any other antenna or

transmitter, except in accordance with FCC multi-transmitter product

procedures