USER’S MANUAL Wicker Chairs Set of 2 HW67786 THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Before You Start Read each step carefully before starting. It is very important to ensure each step followed in correct order, otherwise assembly difficulties may occur. Most of board parts are labeled or stamped on the raw edges. Have a check to make sure all parts are included. Work in a spacious area, preferably on a carpet close to where the unit will be used. Keep the handtools close at hand. Do not use power tools to assemble your furniture. They may scratch or damage the parts.
C B E x2 A D Notice 50% tighten before fixing all screws, Allen wrench is recommended instead of an electric drill. Place the item on a flat ground to adjust and make sure it remains stable. Tighten up all screws with tools gradually. If the screws are not aligned with holes during assembly, please loosen all the other screws to 50% and continue the assembly process. If the item is not stable, please loosen all the screws, adjust it on a flat ground and tighten up all screws again.
Parts List A 2 pcs D B C 2 pcs 2 pcs E 2 pcs Hardware List 1 2 BOLT M6 x 30mm 14pcs STEEL WASHER 3 x 18 M6 04 BOLT M6 x 40mm 8pcs ALLEN KEY 4 x2 M4 2 pcs
STEP 01 4 1 1 D 3 3 A x2 STEP 02 3 4 1 3 1 C 3 2 3 x2 05
STEP 03 B 1 3 3 1 2 3 3 x2 06
STEP 04 2 4 x2 STEP 05 x2 07
Care and Maintenance Use a soft, clean cloth that will not scratch the surface when dusting. Use of furniture polish is not necessary. Should you choose to use polish, test first in an inconspicuous area. Using solvents of any kind on your furniture may damage the finish. Never use water to clean your furniture as it may cause damage to the finish. Liquid spills should be removed immediately. Using a soft clean cloth, blot the spill gently. Avoid rubbing.
