Installation Guide

DO NOT fully tighten all screws until assembly is completed

PART LIST FIGURE QUANTITY DESCRIPTION

A 1 PC RIGHT ARM

B 1 PC LEFT ARM

C 1 PC BACK

D 1 PC SEAT

E 6 + 1 PCS SHORT BOLT (M6*18)

F 2 + 1 PCS LONG BOLT (M6*40)

G 8 + 1 PCS FLAT WASHER

H 1 PC ALLEN WRENCH

I 2 PCS BACK CUSHION

J 1 PC SEAT CUSHION

Page

1/4

ASSEMBLE ON A FLAT, PROTECTED SURFACE.

PAGE 1
ASSEMBLE ON A FLAT, PROTECTED SURFACE.
PAGE 2
STEP 1 A. PLACE RIGHT ARM (A) UPSIDE DOWN ON A FLAT, PROTECTED SURFACE. B. ATTACH SEAT (D) TO RIGHT ARM (A) WITH FLAT WASHER (G) AND SHORT BOLT (E) USING ALLEN WRENCH (H). DO NOT TIGHTEN COMPLETELY. C. ATTACH LEFT ARM (B) TO SEAT (D) WITH FLAT WASHER (G) AND SHORT BOLT (E) USING ALLEN WRENCH (H). DO NOT TIGHTEN COMPLETELY. STEP 2 A. TURN SEAT ASSEMBLY TO UPRIGHT POSITION. B.
PAGE 3
PART LIST FIGURE QUANTITY DESCRIPTION A 1 PC TABLE TOP B 4 PCS LEG C 1 PC LEG CONNECTOR D 12 + 1 PCS BOLT（M6*28） E 12 + 1 PCS FLAT WASHER F 1 PC ALLEN WRENCH Page 3/4
PAGE 4
STEP 1 A. PLACE TABLE TOP (A) UPSIDE DOWN ON A FLAT, PROTECTED SURFACE. B. ATTACH LEGS (B) TO TABLE TOP (A) WITH FLAT WASHER (E) AND BOLT (D) USING ALLEN WRENCH (F). DO NOT TIGHTEN COMPLETELY. STEP 2 A. ATTACH LEG CONNECTOR (C) TO LEG (B) WITH FLAT WASHER (E) AND BOLT (D) USING ALLEN WRENCH (F). DO NOT TIGHTEN COMPLETELY. STEP 3 A. ROTATE TABLE TO UPRIGHT POSITION SO THAT IT STANDS STABLE ON THE FLOOR. B. TIGHTEN ALL BOLTS SECURELY USING ALLEN WRENCH (F).