Owner's Manual

Jeep/Chrysler/Dodge

SGS-CH01 z 11/11

Troubleshooting

Symptom Possible Cause Remedy

Headunit only shows

guidelines in reverse.

The aftermarket camera is not

outputting a picture.

Check to make sure the camera is being

powered on with a digital multimeter.

Test camera with a different display. Plug the

RCA of the camera into a display with a RCA

input.

Alternatively, you can use a different RCA

source into the RCA input. For example, an

old DVD player with a RCA output would

show a picture with the vehicle in reverse.

This will eliminate if the issue is with the

head unit or the camera installation.

Nothing happens when

vehicle is in reverse

The SGS-CH01 is not installed

properly.

Make sure all of the dip switches are in the

off position.

There is a harness that was not plugged in

correctly. Using page 5 or 6 of this manual

check each connection to ensure every

harness is plugged in.

Static Guidelines not showing

The #1 dip switch was not moved

down as shown on page 9.

Remove power and move dip switch position

as shown on page 9.

LED Functions

Spec Parameter

Front Cam Video, Reverse Cam Video 0.5 - 2Vpp with 75 ohm impedance

Reverse Control Wire >5V will force into camera mode

Normal Power Consumption 4.32W (0.36A @ 12V)

Standby Current Draw <20mA

Reverse Trigger Threshold >5V Trigger

Working Temperature -40C to +85C

Dimensions 10.5 x 8.5 x 2.2cm

Specifications

1 The top LED will ﬂash when CAN data is being read by the SGS-CH01

2 The bottom LED will remain on solid when vehicle CAN data is active. It will turn off when the vehicle CAN

data turns off.