Owner's Manual

Connect speaker
connector to an
amplifier (not included)
Place subwoofer enclosure on the seat floor
and connect the speaker connector to the
enclosure.
Enclosure Installation
1.
From Enclosure
Observe speaker polarity when connecting
to the speaker connector.
Ensure wires are not pinched or interfere
with any safety equipment.
Secure the connector plugs to the left
side of the seat as shown below.
5.
Carefully position the passenger seat over the
enclosure while carefully aligning the enclosure
in between the seats brackets. Observe the
direction of the enclosure. Secure using the
18mm seat bolts (4) as shown below.
3. Re-attach the seat belt anchor using the T45 Torx bolt.
Reconnect the two plugs under the seat.
Front ->
2.
Passenger side
UNLIMITED
 5/6
Jeep
Tighten the seat bolts to 55 ft lbs
Tighten the seatbelt bolts to 30 ft lbs
4. Reconnect the battery terminals.