Owner's Manual

■ About Connecting to the Speaker Input Level System
When connecting by using the Speaker- RCA Conversion Cable ( G)) (sold separately), s witch the Speaker
Input Level Switch ( (D ) to "HI' '.
e.g. S-A32F
CD Speaker Input Level Switch 8 RCA Input Jacks
i-,-- /_ I
i lO II ii C~INPUT~-3
1
~ ••@ cuo l
~ T 11 ~ ~~•
, LEVEL ,' @) I
~-~lTl
CB
Head Unit , etc.
G> G> G> G>
Front Speaker output lead (L)
(±) (±)
-
0 0
Front Speaker output lead (R)
(±) (±)
0 0
Rear Speaker output lead ( R)
(±) (±)
0 0
Rear Speaker output lead (L) (±) (±)
0 0
• Do not mistake the Speaker Output Lead on the head unit side connected to this unit .
Front Speaker output (L) / {R) to CH 1 /CH2, Rear Speaker output (L)/(R) to CH3 /CH4
• For the "Speaker Input Level System" setting, connecting the Remote Turn-On Lead is not required due to
the "REMOTE SENSING" function of this product. However, the "REMOTE SENSING " function may not work
depending on the signal source connected. In such a case, connect the Remote Turn-On Lead to an
incoming power supply cord (accessory power) in the ACC position.
■ Important Tips on Bridging an Amplifier
Low output will result if only one channel input is used. The Y-adapter is not required if a stereo/ mono pair
line output is used to drive both inputs of the bridged amp.
0 Prnpe«onne«;on
X lmp,ope, ,onne«;o,
rlNP\/T---, r INPUT----,
CH·1 CH-3 SUB CH-I CH-3 SU8
QQOO
Q(L)@@
@ @ (§
CB
'"~'
CB
QJ~O
Head Unit , et c. Head Unit , etc.
CH-2 H·4 Ste
-
Ooe ,;goal ~
One signal
J
CE) e>
CE)
~
q[]!Dmrn
18 -EN