Owner's Manual
Table Of Contents
- Power Amplifier Owner's Manual
- Contents
- Warning
- Servicw Care
- About the Protection Circuit
- Accessories
- Installation
- Attaching the Logo Plate
- Connections
- Connection Check List
- Switch Settings
- System Diagrams
- Basic Connection Diagram
- 4 Speaker + Subwoofer System
- 2 Speaker + Subwoofer System (Bridged Connections)
- Front 3-Way System
- Front 2-Way + Subwoofer System
- Front 3-Way + Subwoofer / 2 Amplifier System (Connection example with R-A75M)
- About Connecting to the Speaker Input Level System
- Important Tips on Bridging an Amplifier
- Cautions on Power Supply Wires
- Connection example when installing two amplifiers with a fuse capacity of 80 A and one amplifier with 90 A
- Specs
- Cautions on Power Supply Wires Connection
- Warranty
10-EN
Crossover Frequency Adjustment Knob
(LP FILTER)
Use this control to adjust the crossover
frequency between 50 Hz to 400 Hz.
Remote Bass Control
Connect the Remote Bass Control Unit
RUX-KNOB.2 (sold separately) to adjust the
output level remotely. This is not to replace
appropriate gain level setting between the
amplifier and head unit.
Speaker Input Level Switch
Switch according to the Speaker input mode.
a) When making a speaker input
connection with RCA Extension
Cables (sold separately), set to “LO”.
b) When making a speaker input
connection with Speaker-RCA
Conversion Cables (sold separately),
set to “HI”.
[BP-L] Adjustment range [BP-H] Adjustment range
50 Hz 400 Hz 6 kHz
[BP-L] [BP-H]
Adjustment range on the Bandpass Filter
Crossover Frequency