Setup guide

Time Delay Overview
MultEQ determines the default delay during initial Setup. However, there may be times
when the delay needs to be tweaked or temporarily modified. Be advised, any changes
made causes deviation from MultEQ's default specs and no longer conforms to its ideal
sound stage. All channels have delays adjustable from 0 to 10ms in
0.1 ms steps.
Time Delay
1. Press MODE twice to enter Custom Tuning mode.
2. With "PRESET 1" in the display, use the" or • buttons to choose the MIC position
to modify.
a) PRESET 1 refers to the Primary Mic position. PRESET 2 refers to the Second mic
position.
b) Upon making the Mic Position selection, use the ~ button to move to the next
selection mode. The next parameter to modify (Crossover, or Time Delay) is
selected as described below.
* Use the ~ button to return to the PRESET selection mode.
c) Use
the" or. buttons to choose TIME DELAY.
d) Press the ~ button to move to the Channel selection mode.
e) Use
the" or. buttons to select a Channel to modify (FRONT LEFf l/RIGHT
1, FRONT LEFf 2/RIGHT 2, REAR LEFf,RIGHT, SUBWOOFER). Use the ~
button to return to the PRESET selection mode.
3. Time Correction
a) With the desired channel selected, press ENTER, to begin the adjustment.
b) Use the" or. buttons to change the delay (from 0 to 10ms) for each channel.
c) Upon completing the adjustment, press ENTER to exit back to the "TIME DELAY"
sub-menu.
d) If all "TIME DELAY" adjustments have been completed, use the
~ button to
return to the PRESET selection mode. Press ENTER again to exit and save the
adjustments. Selecting "SAVE SETTINGS" stores changes in memory.
e) Use the MODE button at any point, to return to the previous sub-menu. to make
additional adjustments.
NOTES:
• Customization alters the MultEQ post-calibration settings. Doing this
mayor may not
result in an improvement
of the overall sound quality.
• If setup includes a 2-Way output, the FRONT 1 High-pass and FRONT 2 Low-pass
cut-off frequencies should not be altered during customization. If these crossover
points must be changed, the MultEQ calibration must also be rerun.