Setup guide

4. Select the EQ Band to adjust.
a) Use the
Tor .. button to make the selection. In this example, "BASS" (or "MID"
or "TREB").
b) Once the Band has been selected, Press "ENTER" to begin making the adjustments.
5. Modify 3 different EQ parameters: LEVEL, Q, and Fc. Use the ~ or ~ buttons to
choose the parameter to modify. Use the
Tor .. buttons to change the parameter.
a)
LEVEL is adjustable from -6 dB to +6 dB using the T or .. buttons.
This adjustment will effectively lower by 25%
or increase by 400%, the output at
the center frequency. The LEVEL changes in 1 dB steps.
b) Q (Q-factor) is adjustable from 0.5 (wide band) to 2.0 (narrow band).
The Q determines how much the frequencies below and above the center frequency
i
are affected by the LEVEL adjustment in 'a.' Use the Tor .. buttons to choose a
Q-factor from 0.5 to 2.0 in steps
of 0.5.
c) Fc (center Frequency) is adjustable from 30 to 150 Hz.
This is the point
of maximum effect for the EQ LEVEL adjustment. All frequencies
above and below Fc are affected to a lesser degree, depending on the Q setting. The
frequencies are selectable using the
T or .. buttons. They vary for each band and
are listed below.
BASS EQ: Fc
= 30,40,5060,80, 100, 125, 150 (Hz)
MID EQ: Fc = 500, 750, 1k, 1.5k, 2k, 3k, 4k, 5k (Hz)
TREB EQ:
Fc = 6k, 7.5k, 10k, 12.5k, 15k, 17.5k (Hz)
d) Upon completing the adjustment, press ENTER to save values and exit back to the
"CUSTOM EQ" HU orAUX sub-menu headings
of BASS, MID orTREB EQ.
e) Use the MODE button at any point, to return to the previous sub-menu.
Crossover Overview
The PXE-H650 crossover allows custom cut-off points for the high-pass and low-pass
filters
of the Front and Rear speakers and the Subwoofer. This is especially useful when the
factory speakers have been upgraded to handle a much wider audio bandwidth.
Crossover
1. Press MODE twice to enter Custom Tuning mode.
2. Navigate to the right with the right cursor button. With "PRESEf 1" in the display, use
the
Tor .. buttons to choose the MIC position to modify.
a) PRESET 1 refers to the Primary Mic position. PRESET 2 refers to the Secondary
position.
b) Upon making the Mic Position selection, use the ~ button to move to the next
selection mode. The next parameter to modify (Crossover, or Time Delay) is
selected as described below.
* Use the ~ button to return to the PRESET selection mode.