Setup guide

STEP 8:
When position 1 measurement is complete,
the
LED will start flashing and the display
will read "MEASURE
POS 2". Move the
microphone
to where the passenger's
head will be, and close the doors. Press
"front" on the remote
to start measuring
position
2, and the LED will go steady.
STEP 7:
Press the "front" button on the remote
to start measuring position
1. The LED
will change from flashing to steady, and
you will hear the log chirps calibrating
each speaker
in the car.
STEP 9:
Measure at least 2 more positions in the
car (maximum
8) using the same
procedure. Choose additional mic
positions based
on user preference.
After at least 4 mic positions total, press
the "right" button
on the remote to
finish calibration. YOU'RE DONE!
STEP 6:
The PXE-H650's display will now read
"ENTER
TO START MULTEQ".
Press enter, now the display will read
"MEASURE
POS 1 ".
Place the microphone where the driver's
head will be, pointing straight up. Exit the
vehicle and close all doors and windows.
STEP 5:
The PXE-H650's display will now read
"ADJUST XOVER+AMP LEVELS".
Turn all
amp Xovers off, then roughly set
amp gains. Use track 3 on the calibration
disc for this. With Alpine amps,1/2 gain for
front/rear and 3/4 gain for sub works fine.
When finished, press enter.
STEP 1:
Insert included calibration disc, set factory
volume
to 3/4, play track 1. Make sure
factory bass/treble/balance/fader controls
are set flat.
STEP 4:
Press "enter" to start AntEQ. This will take
about 20-30 seconds. After AntEQ is done,
the PXE-H650's display will read "2-WAY
OUTPUT, Y or N". Choose "N" if only the
front 2 output is being used; select "Y" if
both front 1 and front 2 outputs are being
used. Press enter to select.
STEP 3:
Switch to track 2 on the included
calibration disc.
STEP 2:
Power up the PXE-H650; the display will read
"ENTER TO SETUP" so press "enter" to start
the Auto Ranging/Auto Summing procedure.
If the display reads something different refer to
pg.15
of the owners manual for Factory Reset
procedure. The display will
read "CHECKING
INPUTS"; and after 10-15 seconds the display
will
read "ENTER TO START ANTEQ".
PXE-H650
5 MINUTE EZ SETUP GUIDE