Setup guide

5. "MEASURE POS 2"
Reposition the microphone to the secondary position in the vehicle. When ready, exit
the vehicle and press "MEASURE" on the remote control to begin. The MultEQ LED
illuminates a steady green. .
6. "CHK OUTPUTS & MIC"
If the MultEQ LED is blinking fast, something may have happened to the mic during
the user's exit. Make any necessary corrections to position, etc.
It will then be
necessary to restart the calibration sequence.
At this point, press the reset button and
navigate to the "RECALIBRATE MULTEQ" option screen. Press "ENTER" to select
this option. The "2-WAY OUTPUT" screen is displayed. Configure this setting the
same as previous MultEQ sequence. Press "ENTER" and re-check amp and crossover
levels with Track 3 -Pink Noise. Press "ENTER" when ready to restart the MultEQ
calibration sequence. Resume the first MIC position measurement (and speaker
detection) by jumping back to step 3 when ready.
7. Next MIC Position
At the "MEASURE pas 3" display, reposition the microphone to another position.
Repeat Step 5 above for this new position.
Continue this process for up to 5 more microphone positions. 4 calibrated positions is
the minimum for proper MultEQ response. 6 positions is recommended for optimal
results. Normally, the more locations used, the more accurate the final EQ curve.
NOTE:
Mic Position 1 is stored in PRESET
1. Mic Position 2 is stored in PRESET 2.
Equalization and Time Delay will
be optimized for these two positions.
8. Done
After completing the desired number
of MIC positions, press "DONE" while
"MEASURE
pas X" (Where X is either 5,6,or 7) is showing on the display. When
calibration is completed in the last step, "CALCULATING FILTERS" then "SAVING
FILTERS" is displayed on the LCD and finally "ALPINE PXE-H650" is displayed.