Setup guide

Front Panel Chassis
1
USB Port - USB cable required for PC control/setup (PC software on supplied CD)
2 MULTEQ LED - Output for included LED; EQ Status indicator during setup
3 RESET - Press & Release button for: Clear settings, Factory Reset, or Redo MultEQ setup
Rear Panel Chassis
4 POWER SUPPLY
Harness (6-Pin)
• Ground (BLK)
Connect this lead to a good chassis ground on the vehicle. Make sure the connection is
made to bare metal and is securely fastened using a sheet metal screw.
• Battery (YEL)
This is a constant +12V for the main unit.
It will remain powered even when the Ignition
key position
is OFF. It draws minimal current to maintain processor memory.
• Remote OUT (BLU/WHT)
This output can tum on external amplifiers. The signal goes high after the PXE-H650
audio mute is OFF.
• Remote ON (BLU/WHT)
If the OEM head unit is not turning on the EQ using the AUTO RANGING INPUT,
use this wire. Connect this wire to the 'Auto Tum On' lead
of the Factory head unit or a
switched
12 VDC source (Ignition).
• Remote Control (WHT/BRN)
This input provides a means by which an external source, connected to AUX, is controlled.
5 REMOTE IR INPUT (2.5mm mini-phono) - Input for external remote eye (included)
6 WIRED REMOTE INPUT (3.5mm mini-phono) - Input for steering wheel control (factory
option); Note: Using this input disables the factory head unit steering wheel controls.
7 AUX PRIMARY SOURCE - Tum this switch ON, if a factory radio source is not being used.
This accommodates an aftermarket radio using the AUX INPUT.
8 CLIP - This LED is ON whenever the AUX source is over the input limit.
9 AUX INPUT LEVEL - Use this trimmer control to adjust theAUX INPUT below clipping.
10 AUX INPUT - Use this input for an auxiliary source or an aftermarket head with line outputs.
11 MIC - 3.5mm TIS jack for included microphone
12 AUTO RANGING INPUT - Use this input for the factory head unit. This input is 'auto
ranging' to handle a wide range
of factory head unit outputs. It will accept speaker or line level
outputs.
It has 5 input pairs for Front & Rear Left +1-, Right +1-, and Subwoofer +1-.
13 RCA OUTPUT - 2 Front L/R Pairs, 1 Rear L/R Pair, 1 Subwoofer Mono
Front Ll/RI For Factory High-pass Output
Front L2/R2 For Factory Low-pass Output (or Full Range Output)
Rear L/R For Factory Rear, Full Range Output
Subwoofer For Factory Subwoofer Output
Note: OUTPUT: For full-range only, use outputs FRONT l21R2
INPUT: If there is a UR pair of full range outputs available from the factory system (FRONT or REAR)
these should
be used first and connected to inputs L21R2 on the H650. If the factory 2-way
output must be used, connect Tweeter
Left to Ll, Woofer Left to L2, Tweeter Right to RI, and
Woofer Right to R2.