Owner's Manual

Jeep
Wrangler Unlimited  8/10
Installation of the PWE-S8-WRA
1 Position the seat in a secure manner to gain access
to the bottom of the seat.
2 Using a T30 Torx, remove the OEM harness
mounting plate as shown below. Use a panel
removal tool to remove the two plugs from the
mounting plate.
3 Use a 9/32” drill bit to enlarge the two outer
mounting holes of the OEM harness mounting plate.
Clean up any metal shavings or debris before
continuing.
4 Use a #2 Philips screw driver to attach the mounting
brackets to the PWE-S8 with the M4 screws.
Bracket A
Bracket B
5 Secure the two plugs using cable ties to the right
side of the seat as shown below.
6 Align the seat brackets with the PWE-S8 Brackets.
Attach the PWE-S8 using the M6 screws and
tighten using a 10mm socket as shown above.