Owner's Manual

Jeep
Wrangler Unlimited  10/10
Re-installing the Seats and radio
1 Reinstall the seat and the seat belt anchor.
Front Seat Mounting Bolts 75 Nm / 55 Ft. Lbs
Seat Belt Anchor Screw 40 Nm / 30 Ft. Lbs
2 Connect the factory plugs to the seat.
Ensure that the connectors are securely fastened.
3 Connect the harness and the Sub Rem.
4 Connect the T-Harness, Yellow connector, and 4 pin
adapter
To OEM
Headunit
To OEM
Harness
4 pin adapter
Yellow Connector (+12v)
Note: Do not connect the 4-pin harness if RCA cables
are used.
Attaching additional electronics to this connector
may cause damage to the vehicle or PWE-S8.
5 Reinstall Headunit
6 Reconnect negative terminal of the battery
AMP Settings
Recommended Settings.
LP filter
SUB GAIN
Phase = 0° Power Mode SP IN
68-34987Z01-A