Owner's Manual

Toyota Corolla
 7/11
5 Connect the main harness and subwoofer level
knob to the amplifier assembly and align it to the
seat mounting holes.
Front of vehicle
7 Route the main harness along the side of the center
console (as shown below) to the radio cavity and
secure any excess wiring with the provided cable ties.
9 Replace all removed components and re-connect
the Negative (-) battery terminal.
6 Pull the carpet slightly from the left front mounting
bolt are and remove paint to expose bare metal.
Attach the Negative (-) ground from the main
harness with the provided wafer head screw and
lock washer. Note: Be sure to stay clear of the seat
mounting area.
8 Connect the wiring according to the corresponding
system diagram on pages 8,9 or 10. Note: Be sure
to set all gains and crossover settings are as
recommended on the diagrams.
Seat screw cover trimming
Due to the bracket location the rear right screw cover will no longer clip back on unless, the highlighted section is
trimmed out to clear the bracket. Follow the dimensions below to trim the required area.
Trim here
Rear of vehicle
1”
1.5”
1/4”
Installation (continued)