Owner's Manual

Installation
1 Connect the power cable to the Positive(+)
battery terminal at the fuse block in the engine
compartment. Note: The negative terminal should
remain disconnected unit the installation is
completed.
3 Route the power cable thru the rubber grommet on
the firewall on the passenger side.
5 Using a step drill, drill a ½" hole on the center
console compartment and feed the subwoofer level
remote cable thru.
\ I
2 Route the cable towards the passenger side as
shown below.
4 Remove the paint to expose bare metal near
the seat's harness and attach the main harness
Negative (-) ground terminal with the provided
wafer head self tapping screw and lock washer.
6 Mount the subwoofer level remote on the center
console compartment (as shown below) and route
the cable to the passenger side seat.