Owner`s manual

PMD-B200P Version 2.0 Owner’s Manual
54
If you want to change the content of the three data fields on the Map screen, tap .
You have the following data and functions on this screen:
Name Description
or
Shows whether the route data fields show information about the final
destination (checkered flag) or about the next waypoint (yellow flag) .
Field next to the flag Shows the name or number of the current street or road.
Turn Preview Shows the type and distance of the next route event.
Compass Shows the current heading.
Speedometer Shows the current speed both graphically and as a number.
Distance Remaining Shows the distance you need to travel on the route
before reaching your
final destination.
Time Remaining Shows the time needed to reach the final destination
of the route based on
information available for the remaining segments of the route.
The
calculation cannot take into account traffic jams and other possible delays.
Arrival Time Shows the estimated arrival time at the final destination
of the route based
on information available for the remaining segments of the route.
The
calculation cannot take into account traffic jams and other possible delays.
GPS Time Shows the current time corrected with time zone offset.
The accurate time
comes from the GPS
satellites, and the time zone information comes from
the map or it can be set manually in Regional settings.
Altitude
Shows the elevation if it is provided by the GPS receiver.
Speed Limit
Shows the speed limit of the current road if the map contains it.
Opens the Trip Computer screen.
Tap this button if you want to change the content of the three data fields on
the Map screen.
8.1.5.1 Trip Computer screen
The Trip Computer screen provides collected trip data. It can be opened from the Trip Information
screen by tapping .
The fields on this screen are continuously updated while you keep the screen open.
You can switch between the trips, pause then resume them, or reset their data.
You have the following functions on this screen:
Button Description
Pauses the trip currently shown on the screen. Values o
n the screen stop
changing.
This button replaces the previous one if it has been activated.
Tap it to resume
collecting trip data.
Resets all counters of the currently shown trip. Collecting trip data
is restarted only
when Alpine Navigation Software receives a position from the GPS.
,
Cycles through all trips.
130.com.ua
Autogood products internet store http://130.com.ua