Owner`s manual

EN-5
In Case of Diculty
If you encounter a problem, please turn the power o,
then on again. If the unit is still not functioning normally,
please review the items in the following checklist. This
guide will help you isolate the problem. Otherwise
make sure the rest of your system is properly connected,
or consult your authorised Alpine dealer.
No function or display.
• Blown fuse.
- Check the fuse on the battery and ACC lead of the
dock; replace with the proper value fuse (2 A blade
fuse) if necessary.
Touch screen not working.
• Monitor is not touch panel enabled.
- The touch screen feature will work only with an
Alpine touch panel monitor.
• Connection failure
- In some vehicles it may be necessary to connect the
Multimedia Station’s remote turn-on lead (blue/
white) to the ignition lead of the dock.
• Not supported
- The docking adapter does not support PMD-B100 or
PMD-B100P. For those units please use PMD-DOK1.
No GPS signal.
• GPS antenna not connected.
- Connect the provided GPS antenna. For best
reception, ensure that it has a good open view to
the sky and make sure the antenna is not covered
(obstructed) by any metallic surface or object.
Cannot access certain functions.
• Certain functions are disabled while driving.
- Certain menu and functions are disabled while
driving. Pull over and engage the parking brake to
enable these features.
• Certain functions are disabled in docking mode.
- Remove the Blackbird from the dock, and power it
on in the cradle or in standalone mode to enable
these functions.
Unable to receive trac information.
• Antenna disabled.
- If using a stock antenna with an active splitter
system, it might be necessary to use the Multimedia
Station’s remote turn-on lead (blue/white) instead of
the power antenna out wire to continuously activate
the power antenna and/or antenna booster.
• No antenna.
- Make sure an FM antenna is properly connected;
replace the antenna or cable if necessary.
Bluetooth Handsfree is not working.
• Interrupt icon pops up whenever there is a call.
- Please go into the Setup Menu of your Alpine
Multimedia Station. In System Setup, change
Bluetooth setting to NAV. For 2006 and older head
units without a Bluetooth setting DO NOT connect
the Interrupt wire.
• No Audio can be heard during a call.
- Please make sure the Docking Adapter is connected
to the AUX input of your Alpine Multimedia
Station. For 2006 and older head units make sure to
select AUX as source, and answer with your phone.